The principle of the centrifugal humidifier is that the centrifugal rotary plate rotates at high speed under the action of the motor, and the water is strongly thrown out on the atomizing plate, and the tap water is atomized into 5-10 microns of ultrafine particles and then ejected out. After blowing into the air, the air and water particles exchange heat and humidity, to achieve the purpose of fully humidifying and cooling the air.

Working principle of centrifugal humidifier：

Centrifugal spray humidifier can be hung, wall hanging, wall hanging perforation and other arbitrary installation, do not occupy the work site, safe and reliable, high life.

Features of centrifugal humidifier：

1. The jet particles are ejected into ultrafine particles (5-10 microns), which will not produce water drop wetlands.

2. The temperature can be 6-8°C, ventilation and humidification can be selected respectively.

3. Especially suitable for direct humidification in humidity (>60%RH) working conditions.

4. Automatic moisture control.

Centrifugal humidifier applicable occasions:

Because of its large humidification and low power consumption, it is especially used in large area humidification occasions.
Industry: It is suitable for textile, printing, garment processing, wood processing, steel factory, ceramic factory, paint baking room and other industrial production workshop with high humidity requirement (60%RH), especially suitable for industrial and mining environment with heat source difficult to humidify.Agriculture: occasions of use, etc.

Performance standard of centrifugal humidifier:

1.Humidification quantity:

This is the most important parameter of humidifier, some enterprises in order to meet the consumer pursuit of the psychology of humidification, at will mark the humidification amount, so the standard strictly stipulates that the humidification amount should not be lower than the nominal value of the rated humidification amount.

2.Humidifying efficiency:

Refers to the ratio of the actual humidification amount and the input power of the humidifier, which reflects how much humidification amount can be generated per unit power consumption, and is an important index to measure the performance of the humidifier. In order to guide consumers to buy energy-saving and environment-friendly products and encourage enterprises to develop more efficient products, the standard divides the index into four grades: A, B, C and D.

3.noise:

Considering that the humidifier may be used in the bedroom, if the noise is too large, it will have a certain impact on consumers, so the standard has a strict limit on the noise index.

The service life of the

4.Evaporation core (device) service life:

For the direct evaporative humidifier, the evaporator core (device) is the most important component to the performance. With the continuous use of humidifier, the efficiency of the evaporation core (device) will continue to reduce, and the humidification will also continue to decline. According to the standard, when the humidifier’s humidification volume is reduced to 50% of the initial humidification volume, it is regarded as the failure of the evaporation core. For replaceable evaporation core (device), its service life should not be less than 1000 hours.

5.Other features:

Humidifier with softening water, humidity display and other functions:

In order to prevent some products clearly do not have this function, or this function can not play the corresponding effect, and through the means of false publicity to mislead consumers, the standard also put forward specific requirements for these auxiliary functions: for the water softener, the standard stipulates after the softening of the water softener, the hardness of water should not exceed 100mg/L. Before the failure of the water softener, the total amount of water softened should not be less than 100L. For the humidity display, the provisions in the relative humidity is 30% ~ 70% of the range, the humidity display error should be within ±10%, so as not to error is too big but to mislead consumers. In addition, the standard also stipulates that because the water level will have an obvious impact on the performance of some humidifiers, the humidifier should have a water level protection function to prevent consumers from unknowingly making the humidifier in a state of low performance and low efficiency for a long time.